The monocrystalline silicon pressure transmitter has a high measurement accuracy of 0.075%, a 100:1 wide range ratio, high stability, fast response speed, and high reliability. It comes with a built-in Hart communication function for easy manual debugging. It is of intrinsic safety, explosion-proof, and can be equipped with multiple isolation membrane structures. It has multiple process connection standards and is suitable for pressure measurement under micro pressure, absolute pressure, negative pressure, high temperature and high pressure, low temperature and corrosion conditions.

1、 Working principle of monocrystalline silicon pressure transmitter

Composed by utilizing the piezoresistive effect of monocrystalline silicon. Using a single crystal silicon wafer as an elastic element, a set of equivalent resistors is diffused in a specific direction of the single crystal silicon using integrated circuit technology on the single crystal silicon film, and the resistors are connected into a bridge circuit. The single crystal silicon wafer is placed in the sensor cavity. When the pressure changes, monocrystalline silicon generates strain, causing the strain resistance directly diffusing on it to change proportionally to the measured pressure, and then the corresponding voltage output signal is obtained by the bridge circuit.

2、 Technical parameters of monocrystalline silicon pressure transmitter

measuring range?

Relative pressure: 0-400Pa-35MPa

******Pressure: 0-1.75 KPa to 35 MPa

signal output?

4-20mA+Hart communication protocol (two wire system)

measurement accuracy?

Comprehensive error: 0.1% (including linearity, repeatability, hysteresis), special requirements can be set at 0.075%

Long term stability

Better than 0.15% F.S per year

Better than 0.2% F.S in five years

temperature range?

Permissible medium temperature: (-40~120) ℃

Permissible ambient temperature: (-40~85) ℃

Permissible storage temperature: (-40~85) ℃

Temperature influence

Relative to 25 ℃: ≤ ± 0.4% of standard range

Damping time

0~40S continuously adjustable

Anti vibration: 2g 1000HZ ± 0.05% g

Impact resistance: 50g 11mesh

Electromagnetic compatibility characteristics: comply with IEC801 standard

Sensor allows overpressure: 3 times the standard range pressure

Zero point * * * Small alarm current range: 3.8mA

Full scale * * * Large alarm current range: 21mA

Start time: 3 seconds without preheating

Materials in contact with the medium

Process connectors: stainless steel 316, Hastelloy C

Sensor diaphragm: stainless steel 316, Hastelloy C

Materials that are not in contact with the medium

Shell: Die cast aluminum strip with epoxy resin coating

Sensor filling fluid: silicone oil anaerobic oil

On site display: LCD 3 1/2 precision digital display LCD analog strip display

Protection level: IP66

Weight: approximately 1Kg

Explosion proof level Ex d Ⅱ C T5, intrinsic safety Ex ia Ⅱ C T5